First of all, wanna say thanks to chunkyks for such a useful piece of software. I'm tired of freezing my butt off in the car to test every little code change I do. I'm trying to simulate generic obd over can through the ELM. On my local device, the init sequence goes something like...
AT SP 6 // set protocol to iso 15765
AT AT2 // set aggressive timing
AT D1 // set can dlc display
AT H1 // set show headers
AT CAF1 // set can auto formatting
then comm is typically
AT SH // set header
// data reqs
I can't get set protocol to work... how do I use it? Using this link: http://icculus.org/obdgpslogger/manp...der/obdsim.txt as reference.
---------- Post added at 02:46 PM ---------- Previous post was at 02:28 PM ----------
To make this post more useful, I've thrown up the input/output.
Corresponding terminal output:
Successfully initialised obdsim, entering main loop
Adaptive Timing: 2