Custom USB tyre pressure monitoring interface

**mrbean_phillip** · 04-11-2008, 06:20 PM

@rgarjr: It uses std Microsoft HID driver - no need to load "special" driver

The 5V off USB power both PIC and RF receiver.

**rgarjr** · 04-11-2008, 07:08 PM

Sweet. Thanks

**mrbean_phillip** · 04-11-2008, 11:34 PM

No worries

**rgarjr** · 04-15-2008, 11:04 PM

How are the sensors secured on the wheel?

**_Dejan_** · 04-15-2008, 11:59 PM

Sensors are inside tyre(between alloy and tyre)...

**HiJackZX1** · 04-16-2008, 01:00 PM

Originally Posted by rgarjr

How are the sensors secured on the wheel?

The valve stem were you put the air is what holds it onto the wheel. The sensor replaces your original one with the sensors valve stem.

**_Dejan_** · 04-18-2008, 10:40 AM

Im sold first 8 builded boards, now Im complete build 4 boards and have prepared 8 boards to build. After this I don't know when I will continue building...

**_Dejan_** · 04-19-2008, 05:00 PM

Im little update my PAGE
And how look my boards:

**rgarjr** · 04-19-2008, 10:46 PM

Dejan,

Boards look very nice man. I'm seeing that JP1 and JP2 dont have a header pin, did you not put one on there?

**mrbean_phillip** · 04-20-2008, 02:01 AM

JP1 is 5v from USB Interface to the RF receiver, JP2 is RF receiver data out to PIC processor.

They are soledered when you place RF-receiver board onto the PIC USB interface,as those 2 jumpers needs to be bend to fit to RF-Receiver board - if you solder them beforehand, it is difficult to position the RF-Receiver.

They come in the kit anyways.