I got a M1-ATX PSU temporary hooked up on the 12v line in my trunk. I've put anon/off switch in the + and use the PSU in mode 0 (Dumb mode)
When both the car and the PC are running, everything is A-OK, when I turn off the car the pc stays on. But when I start the car while the PC is on the PC turns off.
Won't the M1-ATX compensate/buffer the voltage drop on the car's battery in Mode 0? Or should I use the M1-ATX in another mode then?
And using those mode's, which is the best setting?
Mode = off delay / Hard Off
0 = Traditional PSU (Domme mode)
1 = 5 sec / 45 sec
2 = 5 sec / 2 Hours (Recommended)
3 = 5 sec / Never
4 = 30 sec / 2 Hours
5 = 30 sec / Never
6 = 30 min / Never (Taxi Mode)
7 = 3 Hours / Never
If I use mode 2 my pc will shutdown 5 seconds after I get the keys out of the ignition. I don't want that, it's too fast, I don't want the pc to reboot when I'm at a gasstation or getting something quick.
Best would be a bit of 2 modes, the Off Delay from mode 6 (30mins) and the Hardoff from mode 2 (2 Hours) Is that possible?
Which mode do you use on your M1?