Results 1 to 4 of 4

Thread: Semi-nub Sproggy/Matero 2.6 question 22v10uH & "Pad1"

  1. 04-18-2002, 07:14 PM #1
    CrazyLittle
    CrazyLittle is offline
    Maximum Bitrate CrazyLittle's Avatar
    Join Date
    Jan 2002
    Location
    Oakland, CA
    Posts
    649
    Send a message via AIM to CrazyLittle

    Semi-nub Sproggy/Matero 2.6 question 22v10uH & "Pad1"

    OK - I've got practically everything soldered onto my sproggy board/kit that I ordered from Mastero. I've got two semi-nub questions that weren't made clear to me after reading through the backlogs:

    1) I'm going to need the 3.3v circuit for my ATX board. The 2.5 diagrams on Sproggy's site say to leave "pad 1" open. What exactly is Pad 1 on the circuit board?

    2) I have sets of both 10 and 22uH inductors from Renco and Wilco. Which set do I use? The parts list on Sproggy's site says 22uH, but the component diagram shows the 10uH inductors.
    Reply With Quote Reply With Quote
  2. 04-18-2002, 10:50 PM #2
    THEMP3KID
    THEMP3KID is offline
    Banned
    Join Date
    Jun 2001
    Location
    Adelaide, Australia
    Posts
    687
    Send a message via ICQ to THEMP3KID
    Use the 10uH inductors...
    and, pad 1 is a gap in the PCB track between the outputs of the 2 maxum regulators...
    Reply With Quote Reply With Quote
  3. 04-19-2002, 02:32 AM #3
    CrazyLittle
    CrazyLittle is offline
    Maximum Bitrate CrazyLittle's Avatar
    Join Date
    Jan 2002
    Location
    Oakland, CA
    Posts
    649
    Send a message via AIM to CrazyLittle
    ok - so where did the 22uH inductors come from?
    Reply With Quote Reply With Quote
  4. 04-19-2002, 08:07 AM #4
    THEMP3KID
    THEMP3KID is offline
    Banned
    Join Date
    Jun 2001
    Location
    Adelaide, Australia
    Posts
    687
    Send a message via ICQ to THEMP3KID
    Sorry, I should have said.. either will work fine, but use the 10uH anyways if you have it...
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules