P1900 V2.2 and Mac Mini Questions...
I emailed Carnetix and have not got a response yet and curious about a few things... here is what I wrote:
1) On the input pigtail there are two (2) ground leads and two (2) +12V
constant leads. Can I tie one of each of these back and isolate them? I
assume I only need to connect one of each along with the ignition line...
or can i ground both grounds and supply both red lines with +12V... Let me
know what to do here.
2) I am ordering a MacPac cable as well (on backorder) - So am intending
to use that instead of the supplied output pigtail. Now I have set my
jumpers for having a +12V output for both my secondary out and the DLYON
I will be using the P1900 to power both my Mac Mini and my Dynamix 816
8.6" touch screen (which until I receive assume it runs on a +12V supply -
I can change this if it is different). I am not sure what supply to
connect this to... the DYLON (Pin 4) or the Secondary Connection (Pin 7).
My thoughts were to supply my Audio Amplifer with the DYLON and the LCD to the Secondary Out... Please advise me here.
Any one got any experience with these issues...