Power Supply Installed on a M10000 Motherboard
This power supply will provide power for up to 2 regular sized (3.5") hard drives, a floppy disk or CD-ROM. If using two 3.5" hard drives then be sure they are operating at 5400 RPM. Alternatively, one 7200 RPM drive may be used.
Overload protection: An over load protection will be effected when either of the loadings:+5V & +3.3V exceeds +120% to 160%. The power supply won’t be automatically recovered after the overload being removed.
Power-good signal After power-on with nominal AC input, there might be a turn-on delay between 100 mS to 500mS before the Power Good Signal is issued, which occurs before +5V output reaches its minimum sense level of +4.75V. When turn-off, the Power Good Signal shall go to a lower level for at least 1 mS before +5V falls under the regulation limit.
Turn-on Delay After turning on, at least 20 mS will be needed for the rise of +5V output voltage (measured from 10% point to 95% point on the waveform) to reach its peak. Operating environment Temperature 0 to 40 degree Celsius Relative Humidity 10 to 90 percent, non-condensing
Remote ON/OFF control Logic level is LOW: Output voltage is enabled. Logic level is HIGH or floating: Output voltage is disabled.
Shipping and storage Temperature -40 to +70 degree centigrade Relative Humidity 5 to 95 percent, non-condensing
The power supply has a very low profile for integration into your project, as seen in the above picture.