RRTMS - RoadRunner tire monitoring system extension plugin

Can anyone confirm if the RR plugin only shows data when the vehicle is in motion?

The reason is because i cannot see any data from the RR plugin, but the data seems to show up on TPMS Dr. just fine. Right now the sensors are still in the box, haven't put them on yet.

I won't be able to test this out until i get my new rims on, which could be another couple more weeks.

you will not see data unless they are under pressure, if i remember correct at least 1,2 bars of pressure

you could put them in one of these garden sprays and pump some pressure

:whs: Also, if I remember correctly the sensors go into sleep mode when below a certain pressure for some unspecified time to conserve the battery. Pressure has to go above 15PSI and back down 5PSI to wake them up.

thanks, thats what i thought.
But odd that the TPMS Dr app still shows data.

Guess i'll have to wait until i get my new rims put on.

you dont have to wait.... the garden spray method should be enough, but you have to pump some pressure in it

Quote:

---

Originally Posted by GizmoQ

:whs: Also, if I remember correctly the sensors go into sleep mode when below a certain pressure for some unspecified time to conserve the battery. Pressure has to go above 15PSI and back down 5PSI to wake them up.

---

Oooooh, that's good to know.

Quote:

---

Originally Posted by Robby BMW

I've double check the program and it's working for me.
Check if in your RRTPMS.INI if the option "Pressure" is set to 2 when you select PSI as unit of measurement.

The skin provided with the plugin is just to be used as guideline for develope your own skin.
The skin comands for the spare tyre are:
INDICATORS:
"TMS_ALERT_ST" - Indicates that in the spare tire there is an irregularities.

LABELS:
"TMS_PRESSURE_ST" – Shows the pressure of the spare tire.
"TMS_ TEMPERATURE_ST" – Shows the temperature of the spare tire.

SLIDERS:
"TMS_BATTERY_ST" – Shows the battery charge status of the spare tire sensor.

---

HI Robby
Well i know you did double chk your program...
But still I have the same PROB of KPa and not PSI..
I did chk the INI file and the Pressure is set to 2... yet only KPA is displayed ...and for that matter if I change it to F ... it still Shows C...
That means no matter what combinations i do ... it always show KPA & C.....

Can you pls help...
thanks
vicky

Quote:

---

Originally Posted by vicky_obee

HI Robby
Well i know you did double chk your program...
But still I have the same PROB of KPa and not PSI..
I did chk the INI file and the Pressure is set to 2... yet only KPA is displayed ...and for that matter if I change it to F ... it still Shows C...
That means no matter what combinations i do ... it always show KPA & C.....

Can you pls help...
thanks
vicky

---

Sounds like you have the dll file in the wrong folder. Recheck the install instructions to see ëxactly" which folder to install the dll. Then re register the dll.

Hey dude thanks
well i was NOT able to Regserv32 the DLL file in the skin dir and was some how able to do in thew Win dir..
So now i got it working...
thanks once again

FYI.

I can confirm that the Sensors were in sleep mode.

installed my new tims today and drove a bit. All sensor data now shows up in the plugin.

Turning off the car for a 10-15 mins, and turning it back on, brought the sensor data up immediatly.
So not sure what the timeout interval is.

Anyway...All good.
TPMS Sensor package works as advertised.