Search:

Type: Posts; User: whip; Keyword(s):

Looking for on the store?

Search: Search took 0.04 seconds.

  1. Replies
    94
    Views
    5,879

    Hello again, I haven't been back here for a...

    Hello again, I haven't been back here for a while. The 1st thing that I would do to solve a light dimming problem is something I suggested before. I can not emphasize this too much. Make sure that...
  2. Replies
    94
    Views
    5,879

    Hello again, I haven't been back here for a...

    Hello again, I haven't been back here for a while. The 1st thing that I would do to solve a light dimming problem is something I suggested before. I can not emphasize this too much. Make sure that...
  3. Replies
    94
    Views
    5,879

    What ever your main Ground to your power supply...

    What ever your main Ground to your power supply is.
  4. Replies
    94
    Views
    5,879

    tbird2340 it is possible that the output on your...

    tbird2340 it is possible that the output on your sound card is insufficient to mask the noise you are picking up from you RCA Cables. You should have at least 2 or 3 volts for normal out put to your...
  5. Replies
    47
    Views
    3,123

    Wow Really hijackxz1? speakers on the side of the...

    Wow Really hijackxz1? speakers on the side of the console? That may be good for the phone speaker but if you have any understanding of sound image you would know that that is one of the worst spots...
  6. Replies
    47
    Views
    3,123

    Well I have done many things for a center...

    Well I have done many things for a center channel, some of them are, Mounted a 3.5" coax in and behind the center AC Duct, Under the front defroster in a BMW 5 series. Up from some custom location in...
  7. Replies
    47
    Views
    3,123

    HijackZX1 Said "OK, I understand it guys. So say...

    HijackZX1 Said "OK, I understand it guys. So say a soeaker has 80RMS, rather then get an amp that can say do 70RMS, i should get one that does 100RMS and simply adjus it down. As far as the speaker,...
  8. Replies
    94
    Views
    5,879

    Gee a nice summation guys, I have to maintain my ...

    Gee a nice summation guys, I have to maintain my stand on this matter, you are right in explaining the technical aspects of the amp speaker relationship, but I believe you have the wrong conclusion....
  9. Replies
    47
    Views
    3,123

    dschmittler is correct, as far as surround goes...

    dschmittler is correct, as far as surround goes the sub is not included in any kind of delay so just load it so it can be heard dynamically, which will give you the most excitement from a movie. You...
  10. Replies
    94
    Views
    5,879

    I disagree with soundman on this one, when you...

    I disagree with soundman on this one, when you wire the amp to the highest ohms the amp will not make full power. The amp is rated at 175 watts per channel at 2 ohms. it well be much less 7 or 8...
  11. Replies
    94
    Views
    5,879

    H1 tbird2340, With the 3 ohms front speakers it...

    H1 tbird2340, With the 3 ohms front speakers it will run a little on the hot side but that amp would do fine for good.
  12. Replies
    94
    Views
    5,879

    If you only have 2 channels coming into the...

    If you only have 2 channels coming into the mids/highs amp you can get away with a quality 2 channel amp Like a Punch P200.2 or P300.2, most mids/highs speakers are a 4 ohm load, these amps make full...
  13. Replies
    47
    Views
    3,123

    I like the P3-shallow mount Rockford Fosgate...

    I like the P3-shallow mount Rockford Fosgate Subs. I use the 10" in a .5 cu ft box and they sound assume. You also have to remember to give the sub at least a 1.5 Inch opening at the opening so the...
  14. Replies
    94
    Views
    5,879

    Ok Tbird Refresh my memory on the make and model...

    Ok Tbird Refresh my memory on the make and model amp that you have. Also it is important that you use quality RCA Cables to shield in radiated noise and that the RCA cables be run separate from the...
  15. Replies
    47
    Views
    3,123

    Hello HijackZX1, If you are using a small sub in...

    Hello HijackZX1, If you are using a small sub in a large car you will need to load is so that it is facing rear aprox 6 to 8 inches from the rear hatch. Otherwise you will have a problem hearing it....
  16. Replies
    94
    Views
    5,879

    Hi Tbird2340, I normally don't listen to my Kegs...

    Hi Tbird2340, I normally don't listen to my Kegs of beer but in this case He is right, when the gains are too high the amp will make a hissing noise most noticeable at low volume levels. try setting...
  17. Replies
    31
    Views
    16,451

    txallan, I looked up that amp and it is a mono...

    txallan, I looked up that amp and it is a mono amp those ar just 2 sets of terminals. They do the same thing. As for the wiring I think it would be better to wire the voice coils in series then run 2...
  18. Hafza you need a fuse no further then 12 inches...

    Hafza you need a fuse no further then 12 inches from the battery to protect the wire to the amp
    . If you get a short somewhere in the middle it could start a fire and burn your car to the ground....
  19. Replies
    94
    Views
    5,879

    You should start from page one.

    When installing car audio it's a good idea to fix one thing before taking on another part. Like Chris said your speakers need to mounted tight and with no openings around them. If they do not fit...
Results 1 to 19 of 19