Search:

Type: Posts; User: Virac; Keyword(s):

Looking for on the store?
Page 1 of 2 1 2

Search: Search took 0.08 seconds.

  1. Replies
    26
    Views
    20,620

    Ok good news I ran a bunch of tests on this and...

    Ok good news I ran a bunch of tests on this and got consistant results. gotta love when results converge.

    Without any changes to boot.ini boots in 35secs +- 1.5 secs ( 5 boots )
    With /numproc=2...
  2. Replies
    26
    Views
    20,620

    The numproc is somthing ive used for a while but...

    The numproc is somthing ive used for a while but i dont know if it really does too much, I just use it in hopes that it may save a few clocks. My boot is usually restricted by my IO (hard drives).
    ...
  3. Replies
    7
    Views
    6,709

    1 Device Present 2–3 5 V 4 Manufacturing...

    1 Device Present
    2–3 5 V
    4 Manufacturing Diagnostic
    5–6 Ground

    http://en.wikipedia.org/wiki/Serial_ATA

    edit: i dont know which side is pin 1 but it would probally be the key side...
  4. Replies
    3
    Views
    543

    the opus DCX6.360 would definetly work (tried it...

    the opus DCX6.360 would definetly work (tried it on my Athlon X4 9850 125W) but it doesnt have enough juice to use pci-e gfx cards as well, and there is no connector for it as well.

    Edit: if you...
  5. where did you find that DTD code? ( tring to...

    where did you find that DTD code? ( tring to repicate with a different chip(ati) )
  6. Thread: Amps????????

    by Virac
    Replies
    40
    Views
    2,300

    see my post 18 ...

    see my post 18
    http://www.mp3car.com/vbulletin/1311672-post18.html
  7. Thread: Amps????????

    by Virac
    Replies
    40
    Views
    2,300

    Holy cow thats handy... if only they would have...

    Holy cow thats handy... if only they would have let me use the internets for engineering school tests... (and its been a few years)

    anyways ya i fixed my maths.

    but you are gonna be spending...
  8. Thread: Amps????????

    by Virac
    Replies
    40
    Views
    2,300

    basics of electronics 101 (really really basic)...

    basics of electronics 101 (really really basic)
    an ohm is the measure of the resistance over wire.
    when 2 resistors are in parrallel the resulting resistance is 1/(1/(R1) + 1/(R2)))
    when you have...
  9. Thread: Amps????????

    by Virac
    Replies
    40
    Views
    2,300

    I would probally not go with that amp as it will...

    I would probally not go with that amp as it will underpower the subs badly. this would probally be where you want to be if you have the 2 subs in parrallel
    ...
  10. Thread: Amps????????

    by Virac
    Replies
    40
    Views
    2,300

    What model sony is it then look it up online at...

    What model sony is it then look it up online at crutchfield or sonys site
  11. Replies
    8
    Views
    1,526

    Maybe a graphic to display the way the comunicate...

    Maybe a graphic to display the way the comunicate would help understanding a little better. Sounds good other wise, where do we start.
  12. Replies
    10
    Views
    960

    The m2/m4 do not provide the correct power to the...

    The m2/m4 do not provide the correct power to the motherboard to supply power to a high current pci device. I think the D2x uses a power plug, if so you would have less issues with it, but i would...
  13. There are other choices out there but iguidance...

    There are other choices out there but iguidance is generally the best choice to do it.

    and to get a usb gps dongle to work you have to recompile the latest version

    ...
  14. Replies
    28
    Views
    3,577

    Just as a side note kev when you run configure it...

    Just as a side note kev when you run configure it doesnt check to see if you have libboost-dev installed, or rather just boost.
  15. Replies
    28
    Views
    3,577

    libgl1-mesa-dev? edit and when you say...

    libgl1-mesa-dev?

    edit and when you say freeglut3 is installed is it freeglut3-dev?
  16. Replies
    28
    Views
    3,577

    libglew-(ver)-dev? i think latest is 1.4...

    libglew-(ver)-dev? i think latest is 1.4...
  17. Replies
    28
    Views
    3,577

    try installing freeglut. thats one of many things...

    try installing freeglut. thats one of many things i automatically install on any machine i develop on.
  18. Replies
    0
    Views
    461

    12V out on opus go boom

    So I get my nice new opus into my car. Its in there for about a week then my screen decides it doesnt want to turn on anymore. i take it out look at it and fixed it, ribbon had came off. I got to put...
  19. Thread: M2/car problems

    by Virac
    Replies
    42
    Views
    2,189

    From what I've seen/read. I would say it will not...

    From what I've seen/read. I would say it will not work. The Xonar is pulling near the max of what a pci card is allowed to pull. and the way the M2/M4 works they cannot provide the power.

    I have...
  20. Replies
    51
    Views
    15,875

    Poll: I was kinda torn. I want one now and would be...

    I was kinda torn. I want one now and would be willing to wait for it to support more makes of cars. Either way I will be buying one, tho the illumination and UPS functionality would probably make me...
  21. Wow this is awsome. I can't wait for this to come...

    Wow this is awsome. I can't wait for this to come out it looks amazing. Im so glad you stuck with this.
  22. Thread: M2/car problems

    by Virac
    Replies
    42
    Views
    2,189

    Ya i just got an OPUS DCX6.360 from UPS today...

    Ya i just got an OPUS DCX6.360 from UPS today hooked it up and all of my electrical problems went away.... but created a new problem

    the opus is about 2ce the width and about an inch longer in...
  23. Thread: LinuxICE update

    by Virac
    Replies
    7
    Views
    1,969

    I would like to help out PM sent.

    I would like to help out PM sent.
  24. Thread: LinuxICE update

    by Virac
    Replies
    7
    Views
    1,969

    LinuxICE update

    When/are you going to post a new beta of LinuxICE. Also what version of the Alsa library are you using and is there a way to do somthing like SerialSwitch or AmpCtrl, ie use the DTR line to turn an...
  25. the pins to connect to the pcb are you going to...

    the pins to connect to the pcb are you going to use just a pin connector or a screw on connector.
Results 1 to 25 of 49
Page 1 of 2 1 2