Search:

Type: Posts; User: KyferEz; Keyword(s):

Looking for on the store?
Page 1 of 12 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    10
    Views
    947

    Kamikaze, thanks for the input, but for what I'm...

    Kamikaze, thanks for the input, but for what I'm doing it doesn't matter where it still allows for cranking - I simply needed to know via an electrical signal if the transmission is in a non-moving...
  2. Replies
    10
    Views
    947

    I found out what I needed - On most automatics...

    I found out what I needed - On most automatics there is a sensor in the transmission called a neutral safety switch that is used by the car to prevent cranking it while in gear.

    Thanks everyone,...
  3. Replies
    10
    Views
    947

    Detect if vehicle is in park

    Does anyone know anything about detecting if a vehicle is in park? Specifically a 2005 or 2006 Toyota Tundra.

    Is there a signal wire or something that could be tapped into?

    Thanks,
    KyferEz
  4. Replies
    4
    Views
    3,829

    Please stop trying to go to the Installation...

    Please stop trying to go to the Installation Manual link in the above post. The Link is incorrect. Here is the correct one:

    Installation Manual

    Thank you,
    KyferEz
  5. Replies
    13
    Views
    934

    I am sorry Jeff, my only intent was to compare...

    I am sorry Jeff, my only intent was to compare 0805 smds with 1/4watt through-holes, not to make anyone think you used 0805 smd parts.

    Travis (aka KyferEz)
  6. Replies
    13
    Views
    934

    Dug, I know this is an older thread, and maybe...

    Dug, I know this is an older thread, and maybe you went somewhere else or already made a purchase, but I thought I, as the designer of the CarPC Power Controllers would make a few comments:

    Anyone...
  7. Replies
    5
    Views
    782

    accelrate, By modifying a setting in the...

    accelrate,

    By modifying a setting in the configuration of the CarPC EZ, you should be able to get it to work the way you want.

    With the config settings at default, the CarPC EZ will begin the...
  8. Replies
    2
    Views
    724

    Jay, first you need to know that the 625 amps is...

    Jay, first you need to know that the 625 amps is CCA, or cold cranking amps. This does not help you to determine how long the battery will last running a constant load. You need to look for a rating...
  9. Ok, check your private message and we will...

    Ok, check your private message and we will arrange for the replacement chip tp be sent to you.

    KyferEz
  10. Replies
    9
    Views
    1,133

    While there is no way for me to tell for a...

    While there is no way for me to tell for a certainty from here (but Mastiff can test for it), it seems to me as though the voltage drop may be coming from the relay itself. If this was the case,...
  11. Replies
    9
    Views
    1,133

    I 2nd the "use the relay to control the...

    I 2nd the "use the relay to control the inverter's switch" method.

    KyferEz
  12. Sorry for the delayed responce. The only other...

    Sorry for the delayed responce.

    The only other cause of this could be that the PC's +5v rail does not power up soon enough after the power signal is sent to the PC. This can only be corrected with...
  13. I forgot to mention, before doing step 1, make...

    I forgot to mention, before doing step 1, make sure None of the jumpers are On.
  14. If when the PC begins to kick into hibernation,...

    If when the PC begins to kick into hibernation, if you can hop out real quick and check the LEDs to be sure what caused it... You are correct tho, the Temp sensors are most likely the cause of that....
  15. Ok, so there are still 2 issues then, correct? ...

    Ok, so there are still 2 issues then, correct?

    1) You said the amp control line is still turning on and off. When does this occur, and does it ever go away? If the amp line keeps turning on and...
  16. That was it, this is something else causing a...

    That was it, this is something else causing a similar problem.

    Are you sure it is the PC that is turning on for a split second (and it's not more like 10 seconds)?

    If the PC turns on for 10 sec...
  17. I sent you a PM in reply to your email. I could...

    I sent you a PM in reply to your email. I could not respond to your email for some reason your mail servers kept sending it back to me.

    At 1st glance, it looks as though you may not have the Temp...
  18. Replies
    176
    Views
    21,949

    Dragon: We at TheCarPCStore.com will be happy...

    Dragon:

    We at TheCarPCStore.com will be happy to be an International Distributor and a USA repair center.

    If you are interested, just let us know when any products are complete, and we will...
  19. A little more info about grounding... It's not...

    A little more info about grounding...

    It's not always a good idea to ground directly to the battery, as long lengths of wire can be the cause of ground loops as well, as previously stated. If you...
  20. Replies
    7
    Views
    1,059

    Just to let everyone know, if you have a CarPC EZ...

    Just to let everyone know, if you have a CarPC EZ or Pro or Platinum v2.4 or v2.45, there is an update that allows you to use these digital inverters that require pushbutton inputs. We will swap you...
  21. Replies
    4
    Views
    1,191

    The most likely problem is that you don't have...

    The most likely problem is that you don't have the PC monitor wires connected (the white molex connector). If you aren't going to use that, then you must disable the PC Monitor in the configuration...
  22. Replies
    17
    Views
    1,993

    I was just wondering. I starting experiencing...

    I was just wondering. I starting experiencing some trouble with my inverter right after installing a surge suppressor, and was curious if this was a similar situation.

    I have the exact same setup...
  23. Replies
    17
    Views
    1,993

    I don't want to steal the thread, but the...

    I don't want to steal the thread, but the shutdown controller is likely acting weird as a direct result of the inverter not coming on, and therefore the PC not coming on. The SDC's PC Monitor sees...
  24. Thread: Power

    by KyferEz
    Replies
    1
    Views
    681

    Both a distribution block or a terminal off the...

    Both a distribution block or a terminal off the cap are fine to hook up power to the PSU, as long as you have sufficient gauge wires to and from the cap or distribution block.

    KyferEz
  25. Replies
    7
    Views
    2,612

    Actually, most everything you ever decide to open...

    Actually, most everything you ever decide to open up will have the batteries in series, not parallel. You do need to isolate batteries running in parallel from each other for a "proper" install. Yes,...
Results 1 to 25 of 295
Page 1 of 12 1 2 3 4