Search:

Type: Posts; User: The unL33T; Keyword(s):

Looking for on the store?
Page 1 of 3 1 2 3

Search: Search took 0.02 seconds.

  1. Would a 1/2 DIN EQ device like I mentioned above...

    Would a 1/2 DIN EQ device like I mentioned above not work for you? My only issue with that idea was trying to figure out how to integrate my steering wheel volume controls into it.
  2. Replies
    376
    Views
    141,603

    Is there any easy modification that could be done...

    Is there any easy modification that could be done to this unit to have it remember if the device was turned on or off before the car was turned off?

    For example, if I turned off the screen last...
  3. Replies
    0
    Views
    550

    Fuse Aux Battery?

    This has probably already been asked before but I couldn't find it. I also already read up on the tank circuits.

    I'll be adding an auxiliary deep cycle battery to power my carputer, amps, etc. ...
  4. Replies
    16
    Views
    1,880

    Go to VWVortex.com and read the DIY guides. It...

    Go to VWVortex.com and read the DIY guides. It will tell you in there how to remove your radio.
  5. Replies
    16
    Views
    2,543

    I would suggest an amp that is less powerful than...

    I would suggest an amp that is less powerful than the speakers to someone that I thought might not pay attention to his adjustments and could potentially push the gain to full on the amp. A low...
  6. Replies
    7
    Views
    2,576

    If I had a free $200 right now I'd definitely...

    If I had a free $200 right now I'd definitely pick one up.
  7. Thank you for clearing that up! If I managed to...

    Thank you for clearing that up! If I managed to create some kind of adapter would that be good for picking up FM stations still? I really just want radio as I don't think I will pick too much up in...
  8. I tried searching but couldn't find any info on...

    I tried searching but couldn't find any info on how to connect the stock antenna to a FM/TV tuner. I would imagine a simple adapter could do it but from the stuff I read so far it seems like the...
  9. Hmm I tried a search and didn't seem to get any...

    Hmm I tried a search and didn't seem to get any useful info. I guess I shall have to search harder.
  10. Most commonly used Radio Receiver for CarPC

    Hello all,
    I was wondering what the users of MP3Car use for receiving radio on their CarPC...

    Personally I'm looking towards the radioSHARK but from looking at the website it doesn't look like it...
  11. Replies
    2
    Views
    11,032

    You could build one for like $5. All you need is...

    You could build one for like $5. All you need is a logarithmic potentiometer. You should be able to find them in any store that sells electronic components. You'd have to find a stereo one though...
  12. AutoIt?

    I've never used AutoIt before but anyone who has do you think it would be easy to create a more "touchscreen-friendly" UI to integrate with the sound card drivers to allow the adjustment of the...
  13. Tell him Best Buy lied to him and they're just...

    Tell him Best Buy lied to him and they're just trying to get him to buy stuff from them instead. Maybe he will shift his ignorance and blame to them instead of you :D
  14. Fader, Balance, Sub Volume Control w/o Headunit or EQ?

    Hello all,

    I've been struggling to find a location for my stock head unit if I want to put my LCD where my current head unit is. I decided it is too much work and unnecessary so I'm going to get...
  15. Replies
    203
    Views
    17,516

    Looks good...

    Looks good http://images.zeroforum.com/smile/emthup.gif
  16. Replies
    34
    Views
    3,193

    There are some hard drive based MP3 players that...

    There are some hard drive based MP3 players that play formats like FLAC. Check out some stuff by iRiver... I know Rio had a few too but they got sold to someone I think.
  17. Replies
    30
    Views
    2,438

    I hear that the foam stuff that goes under carpet...

    I hear that the foam stuff that goes under carpet before you put it down works semi-ok and is much cheaper than dynamat. I used it on my last car to eliminate the vibration noise my rear licence...
  18. Replies
    7
    Views
    1,670

    The LM2678 regulators are rated for 5A so as long...

    The LM2678 regulators are rated for 5A so as long as he draws less than that on each rail then technically it should work. You can always use a couple in parallel if current demands are too high. I...
  19. My plan is just to use the Blitzsafe CD changer...

    My plan is just to use the Blitzsafe CD changer to Aux input adapter and keep the stock stereo. I don't have a Monsoon system though.
  20. Replies
    9
    Views
    887

    The voltage regulator only needs to be equal or...

    The voltage regulator only needs to be equal or above 12V to output 12V. If it is less than 12V then it will output whatever the input voltage is. If you are concerned about voltage drop while...
  21. Replies
    9
    Views
    887

    You can get a 12V regulator from an electronics...

    You can get a 12V regulator from an electronics part store. It will output a constant 12V as long as the input voltage is equal or more than that. They are pretty cheap (5 for $5 CAN) and rated at...
  22. Replies
    11
    Views
    1,373

    I think I saw 200A relays on eBay specifically...

    I think I saw 200A relays on eBay specifically for battery isolation for $20US each. I could be mistaken.
  23. I'll probably try this if I cannot find this...

    I'll probably try this if I cannot find this green foam spray stuff mentioned. I just didn't think it would work because of the dripping but after a little more reading and thinking I guess it makes...
  24. Which green shit would that be? Also, I found...

    Which green **** would that be?

    Also, I found out that Canadian Tire sells fiberglass matt and fabric for $7.99 and $5.99 per square meter. They have both on a roll in the automotive department. ...
  25. 1. How could I make a mold of the underside of...

    1. How could I make a mold of the underside of the rear deck that is stiff enough to maintain its shape while the fiberglass dries? I cannot remove the rear deck from the car to mold the underside...
Results 1 to 25 of 59
Page 1 of 3 1 2 3