Search:

Type: Posts; User: Extide; Keyword(s):

Looking for on the store?
Page 1 of 6 1 2 3 4

Search: Search took 0.07 seconds.

  1. What MCu are you using? Sounds pretty slick.

    What MCu are you using? Sounds pretty slick.
  2. Replies
    76
    Views
    8,323

    It would be really easy to make a RRconfig in C#....

    It would be really easy to make a RRconfig in C#. Just make a class that can represent all your settings, add it as a data source and then drop it on a form, bam all the settings labels and text...
  3. Replies
    3
    Views
    680

    Its the green wire on the ATX connector, short...

    Its the green wire on the ATX connector, short that to ground and the PSU should turn all the rails on. Otherwise only the +5v standby should be on. Essentially when the M2 tells the mobo to turn on...
  4. Replies
    5
    Views
    834

    Dont forget the arrandale has much(all?) of the...

    Dont forget the arrandale has much(all?) of the northbridge, including the graphics inside that 18w. So it's not really fair to say 10w vs 18w, and I bet that the penryn northbrige+IGP uses more than...
  5. Replies
    5
    Views
    6,912

    Yeah this thing seems easy, but it would create a...

    Yeah this thing seems easy, but it would create a ground loop, too. Those specs sounds like it just uses a 7805.

    I run ground, +5 and +12 from the rear of the car where the carpc is to the front...
  6. Surprised it hasnt been mentioned yet, but the...

    Surprised it hasnt been mentioned yet, but the vortex (www.vwvortex.com) and it's subsidiaries are the largest car forum on the web.

    They have many, a mazda one, a subaru one, a bmw one, an audi...
  7. I have a E6300 (newer gen one, 45nm 2mb L2,...

    I have a E6300 (newer gen one, 45nm 2mb L2, 2.8GHz), it is MORE than enough. Heck my old Pentium M 1.5 was just about enough (but I really wanted dual core for win 7 it was ~slow on the p-m.)
    ...
  8. Replies
    48
    Views
    12,277

    This is an MTK2 chipset receiver (by the specs)....

    This is an MTK2 chipset receiver (by the specs). You can use the Qstarz GPS utility to configure it and change the update rate, the port speed, and the messages it sends, no need to do any filtering...
  9. Replies
    8
    Views
    1,179

    All GPS's (I have seen) work as USB to serial,...

    All GPS's (I have seen) work as USB to serial, some just have the USB to serial stuff built into the GPS, so they detect as a USB to serial adapter themselves. Make sure you have the com port...
  10. Replies
    10
    Views
    1,047

    Just use a Y off the green port (this is the...

    Just use a Y off the green port (this is the fronts) to both of your front sets (tweeters and mids)

    Right now you are sending Front to the tweeters and REAR to the mids. You want front to both......
  11. Replies
    13
    Views
    952

    FWIW Desktop drives use +5v and +12v and I think...

    FWIW Desktop drives use +5v and +12v and I think laptop drives can be ran on only +5v but they may also require +12v also.
  12. Replies
    13
    Views
    952

    I rock a 60GB SSD as my OS drive and then I have...

    I rock a 60GB SSD as my OS drive and then I have a 1.5TB drive in a little external SATA enclosure and just run SATA & power to it from inside my carpc. I used to use a USB HDD for data, and it works...
  13. Replies
    17
    Views
    1,693

    Doubtful, especially with a short

    Doubtful, especially with a short
  14. Replies
    8
    Views
    3,839

    Yeah I would go ahead and do that and plug it in...

    Yeah I would go ahead and do that and plug it in and see what you can sniff off the bus.
  15. Replies
    17
    Views
    1,693

    I dont think his question was too abstract...

    I dont think his question was too abstract...
  16. Yeah, this is normal. Your mobo has a 24-pin port...

    Yeah, this is normal. Your mobo has a 24-pin port on it, and the M2 only has a 20 pin cable. The connector should only fit in one way, and then leave the other 4 pins un-connected. It should still...
  17. Replies
    8
    Views
    3,839

    An Elantra may be entirely different. For...

    An Elantra may be entirely different. For example, on VW/Audi cars you can get access to everything via the OBD port.
  18. Replies
    17
    Views
    1,693

    Because the 12v in the dash isnt regulated. Car...

    Because the 12v in the dash isnt regulated. Car 12v generally runs around 14v and jumps all over the place, electronics don't really like that.

    Personally, I run +12v and +5v from my pc's PSU to...
  19. Thread: Dev Queestion

    by Extide
    Replies
    4
    Views
    674

    Cool, I will check out the bass lib stuff. I have...

    Cool, I will check out the bass lib stuff. I have been away on holiday for the thanksgiving weekend but I am flying back home now so I should have some time to look into it in the next little bit...
  20. Thread: Dev Queestion

    by Extide
    Replies
    4
    Views
    674

    BTW I also noticed a bit of a bug, in your...

    BTW I also noticed a bit of a bug, in your closeRenderer method on the UI form (which I would HIGHLY suggest renaming to something like 'MainForm' as there is also a plugin DLL called UI and that is...
  21. Thread: Dev Queestion

    by Extide
    Replies
    4
    Views
    674

    Dev Queestion

    How come the folder structure in the SVN tree is such that the plugins aren't in the right folder for the solution file to pick them up automagically. How do you have your dev box setup? Should I...
  22. Replies
    10
    Views
    21,701

    Well, there is still the atmospheric effects...

    Well, there is still the atmospheric effects...
  23. Replies
    12
    Views
    1,918

    What's it written in? Is it open source?

    What's it written in? Is it open source?
  24. Replies
    22
    Views
    6,386

    How much are you selling that for?? MTK...

    How much are you selling that for??

    MTK chipset is way better than Sirf3 ! Glad people are finally starting to use it. I have an older MTK1 chip based GPS but it only does 9600baud on the serial...
  25. Replies
    5
    Views
    1,266

    If the mac can output 4-channel audio, then you...

    If the mac can output 4-channel audio, then you should be able to turn down the front 2 channels.

    If not, (and you can only output 2-ch) then you would either need to
    -on-the-fly adjust the gain...
Results 1 to 25 of 139
Page 1 of 6 1 2 3 4