Search:

Type: Posts; User: mattwz; Keyword(s):

Looking for on the store?
Page 1 of 3 1 2 3

Search: Search took 0.02 seconds.

  1. Replies
    12
    Views
    1,410

    Well I was playing around with the volume...

    Well I was playing around with the volume calculator, and came up with these dimensions. These aren't final, but I wanted somewhere to start. I'm obviously not good at drawing stuff up in paint,...
  2. Replies
    12
    Views
    1,410

    So the 2 chambers are completely sealed off from...

    So the 2 chambers are completely sealed off from one another? I'm going to make a sealed box since it's easier to make. Plus I think I would like the bass tighter, and more accurate. All of the...
  3. Replies
    12
    Views
    1,410

    Thanks for the replies. How would I separate the...

    Thanks for the replies. How would I separate the 2 chambers? I've never seen the inside of a sub box before, so I don't know how the two sides are separated.

    Thanks
    Matt
  4. Replies
    12
    Views
    1,410

    Thanks, just wanted to make sure. I have a...

    Thanks, just wanted to make sure.

    I have a question about building the sub enclosure. The specs say the recommended cubic feet for a sealed enclosure is 0.85 - 1.5. I'm guessing I have to...
  5. Replies
    12
    Views
    1,410

    Well I checked out this...

    Well I checked out this http://www.the12volt.com/caraudio/woofer_configurations.asp on the12volt.com, and it came out to a 1 ohm load when wired in a parallel configuration. I just bought both the...
  6. Replies
    12
    Views
    1,410

    Amp/Sub Ohm's Confusion

    I'm planning on buying a pair of Alpine SWS-1242D subs, which according to the specs run at 4 ohms.
    For the amp, I want to buy the Hifonics BX605. According to the specs, it runs at 600 x 1 RMS @...
  7. Replies
    7
    Views
    1,073

    I've been very busy with work for the past few...

    I've been very busy with work for the past few weeks, and I've finally got a chance to start working on this again. I was looking into getting this amp...
  8. Replies
    4
    Views
    2,392

    Good site to learn about car audio?

    I'm looking for a site that can give me a better understanding of car audio. There's a lot of terms that I've heard, and kind of know what they mean, but I don't know how it exactly works. Such as:...
  9. Replies
    7
    Views
    2,289

    Multi Amp Kit, Any Specific Bundles?

    Hello,

    I'm trying to decide on what type of power wires I should buy, and how to run it through the car. What I want to do is have 1 power wire ran to the trunk, and split off to the other...
  10. Replies
    7
    Views
    1,073

    Thanks for the replies. Any recomendations on a...

    Thanks for the replies. Any recomendations on a Hifonics model and subs to go with it?

    I'm thinking about running a 4awg wire from the battery to a distribution block in the trunk, and split...
  11. Replies
    7
    Views
    1,073

    Please help me pick out an amp

    I had new speakers installed around a year ago, and I've been running them off my head unit. Now that I'm putting in an LCD, I don't have room in the dash for the head unit. I'm looking to get a 4...
  12. Replies
    12
    Views
    1,994

    Yep, 93 Bonneville. I looked at some pictures of...

    Yep, 93 Bonneville. I looked at some pictures of a 99, and the dash's look pretty much the same. You might still be able to fit the controls at the bottom of the dash where it curves. Moving them...
  13. Replies
    12
    Views
    1,994

    Ok cool. I just ordered the 7" Lilliput from the...

    Ok cool. I just ordered the 7" Lilliput from the mp3car store :) I'll check how far I can move the heat/air controls when I get the LCD. I don't want to keep removing the dash because the tabs...
  14. Replies
    3
    Views
    885

    Thank for the reply. I might wait out and...

    Thank for the reply. I might wait out and fabricate the dash, run cables, ect in the meantime, and get DragonBTV's power supply as the last thing. Hopefully it will be out by that time.

    Is the...
  15. Replies
    3
    Views
    885

    Opus 150W, No Amp Control?

    I was looking to get the Opus 150W PS, but I noticed I didn't see anything about powering on other devices, such as amps to prevent from the thump that occurs when the PC is turned on. For $180 I...
  16. Replies
    12
    Views
    1,994

    The fan speed and temp controls are electronic...

    The fan speed and temp controls are electronic and the duct control is vacuum, I think. Is it alright to pull it out?
  17. Replies
    12
    Views
    1,994

    Ok thanks. Do you know what type of bondo I...

    Ok thanks. Do you know what type of bondo I should use? My understanding is that there are a lot of different types of bondo. What would work well with the plastic dash? I'm not sure how I will...
  18. Replies
    12
    Views
    1,994

    Dash Layout Help

    Hello,

    I'm trying to plan out the layout of my dash. I'm taking out my current head unit and replacing it with a 7" Lilliput LCD (ordering this week). What I want to do is have the LCD at the...
  19. Replies
    4
    Views
    851

    Thanks for the replies. I was thinking about...

    Thanks for the replies. I was thinking about going with the laptop too, but it isn't very reliable. It freezes pretty often, and I tired running it on the battery recently, and it only lasted a...
  20. Replies
    4
    Views
    851

    Suggestions for PC Parts?

    Well I've been reading here for awhile and kept putting the project off since I haven't had the money to buy anything. I have some time and money now to put into the project :) So I'm ordering the...
  21. Replies
    4
    Views
    1,842

    Thanks for the info! How hard is it to remove...

    Thanks for the info! How hard is it to remove the back seat on most cars? I was looking at this LCD at digitalww, and seems like a good deal since I know I wouldn't do too good with the...
  22. Replies
    4
    Views
    1,842

    CarPC Setup Advice...

    Well I haven't visited here in awhile, but I got some extra money, and was thinking about getting this project started. I have a 93 Pontiac Bonneville

    First I was probably going to build a PC...
  23. Thread: IR Help...

    by mattwz
    Replies
    8
    Views
    811

    Sorry, I spelled it wrong.. Here's the link...

    Sorry, I spelled it wrong.. Here's the link.
  24. Thread: IR Help...

    by mattwz
    Replies
    8
    Views
    811

    Maybe Grider (http://www.grider.nl) could be used...

    Maybe Grider could be used for this. You would have to program every key. But maybe there's another program that someone knows of that will work better?
  25. Thread: IR Help...

    by mattwz
    Replies
    8
    Views
    811

    Read this thread here...

    Read this thread here. I guess you need to program all the keys in manually.
Results 1 to 25 of 51
Page 1 of 3 1 2 3