Search:

Type: Posts; User: nate131; Keyword(s):

Looking for on the store?

Search: Search took 0.01 seconds.

  1. Replies
    9
    Views
    825

    This looks promising, i will try these drivers...

    This looks promising, i will try these drivers out tonight, thanks ClockWorK
  2. Replies
    9
    Views
    825

    When I run the basic windows calibration messes...

    When I run the basic windows calibration messes it up even more. I was hoping there would be some software with the driver to be able to invert axis or figure out to invert based on its calibration
  3. Replies
    9
    Views
    825

    From the instructions and pictures sent to me by...

    From the instructions and pictures sent to me by TFT_LCD i have done it the right way, i guess i could mount it upside down from what was told to me but i would much rather some sort of driver pack...
  4. Replies
    9
    Views
    825

    From the pictures that were sent to me by tft_lcd...

    From the pictures that were sent to me by tft_lcd it looks like i have moutned it the correct way up. I could mount it the other way but then it would jut out slightly. I cant believe there is no...
  5. Replies
    9
    Views
    825

    I have also tried on a desktop running windows 8...

    I have also tried on a desktop running windows 8 with ATI 4800 graphics with the same result now. Hopefully someone has a solution to this.

    Touch controller shows up as:

    Hardware ID's...
  6. Replies
    9
    Views
    825

    Atmel maXTouch 7" inverted axis

    I recently purchased the following item on ebay:

    http://www.ebay.com.au/itm/181195109829

    Everything has gone well to install it however I am testing my setup using a laptop outside of my car...
Results 1 to 6 of 6