Search:

Type: Posts; User: matthud; Keyword(s):

Looking for on the store?

Search: Search took 0.01 seconds.

  1. There is no ECU. That is the problem. I am...

    There is no ECU. That is the problem. I am working on a project that has a ELM interface to drive a gauge console. So without the ECU and other systems the Reduced Power message gets sent. I need...
  2. Need help with turning off "Reduced engine power" message on DIC

    I am looking for the GM message(s) that are needed to turn off the Reduced Engine Power message that appears on the drivers information center on a 98 Corvette. I only need the J1850 messages that...
  3. Replies
    12
    Views
    3,216

    I was able to find the message formats in the SAE...

    I was able to find the message formats in the SAE J2178 books, and I am able to command the fuel level, oil level and water temp. But about 5 seconds after I command it, the gauges go back to the...
  4. Replies
    12
    Views
    3,216

    I figured this was one of the GM proprietary...

    I figured this was one of the GM proprietary messages, and not one of the SAE standards.
  5. Replies
    12
    Views
    3,216

    Can anyone decode this message for me: CC 10 60...

    Can anyone decode this message for me:
    CC 10 60 19 12 FF FF 3E

    I know about the header and the crc, so I guess the 19 12 FF FF is what I need to know. I have an elm interface and the dash. I am...
  6. Replies
    1
    Views
    816

    Any Class 2 Serial Experts Check In

    I am currently working on a project where I am trying to set the gauge values on an IPC from a 99 Vette, its stand alone outside of a car. I have the circuitry that allows me to send and read the...
  7. Replies
    12
    Views
    3,216

    If you could send me what you found for your...

    If you could send me what you found for your Chevy dash, it might give me a starting point.
  8. Replies
    12
    Views
    3,216

    I do not have a vehicle to sniff on. I am...

    I do not have a vehicle to sniff on. I am putting a gauge cluster in a project car with a non GM PCM.
  9. Replies
    12
    Views
    3,216

    Thats exactly what I am trying to do, control the...

    Thats exactly what I am trying to do, control the dash gauges from a microcontroller or PC. Would you happen to have any of the commands necessary to talk to the dash(IPC).

    I was looking into...
  10. Replies
    12
    Views
    3,216

    Ok, thats exactly what I want to do, control the...

    Ok, thats exactly what I want to do, control the gauges with the serial data.

    I want to see about putting messages into the DIC display, not re-purpose the button.
  11. Replies
    12
    Views
    3,216

    Looking for info on GM Class 2 Dash Control

    I am trying to control a GM dash that uses class 2 serial data (J1850 VPW), to control the secondary gauges. I am looking for the control PIDs that are used to command these gauges. Or does the...
Results 1 to 11 of 12