Then Im sell this CARPC and start build new INDASH CARPC
First Im buy few new things.
Then Im buy components:
-MainBoard: VIA PICO PX 10000G Pico-ITX
-Ram A-DATA SO DDR2 1GB 533MHz
-HDD 2.5" WD 1600BEVS S-ATA
-Adapter SATA-HDD 2.5" to SATA-MB and Power
-Power Suply M2-ATX 6-24V DC/DC (160 Watt)
-Monitor LCD TS CTF800
-GPS OEM GlobalSat ET-332
Then Im start making mask for LCD:
and building TPMS:
And then Im find first little problem. I need case for carpc. hmmmmmmmmm where can I get it? Maybe build it from old PC case? no to hard And Im find old radio from mothers stilo Looks nice maybe I can use it
Time to destroy it
And with new mask for LCD:
On this picture you can see MB, HDD & GPS:
then Im put HDD on rubbers:
And build audio connector:
then Im stop my project because pico MB doesn't support S3 power state and Im sell it. Yesterday Im receive new board VIA EPIA NX15000G and continue building CARPC. Im change positions of components, HDD & M2-ATX power suply is below MB. I will post new pictures today at the evening or tomorrow...
That is all for now...