MP3Car.com - View Single Post

bambam · 07-25-2007, 09:42 AM

Quote: Originally Posted by guizai

take the whole piece out and use painters tape. Place the dash piece face down, level the area. Place the screen in the exact position you want it in the gap. Pour ABS sludge around the bezel into the gap between dash piece and bezel. Make sure you pour slow to avoid air pockets. Let dry and sand away. That's how I would do it at least.

Man, I would have to disagree with this. The abs sludge WILL warp your bezel, I know, I just worked with it. I read a thread on this site about Dynatron and went that route and it worked great. I used ABS sludge to make a mold, carved it out and then used Dynatron to bond the 2 together.

Just my $0.02

http://www.mp3car.com/vbulletin/show...t-monitor.html

07-25-2007, 09:42 AM	#4
bambam Constant Bitrate Join Date: Dec 2004 Location: Upstate New York Posts: 210	Quote: Originally Posted by guizai take the whole piece out and use painters tape. Place the dash piece face down, level the area. Place the screen in the exact position you want it in the gap. Pour ABS sludge around the bezel into the gap between dash piece and bezel. Make sure you pour slow to avoid air pockets. Let dry and sand away. That's how I would do it at least. Man, I would have to disagree with this. The abs sludge WILL warp your bezel, I know, I just worked with it. I read a thread on this site about Dynatron and went that route and it worked great. I used ABS sludge to make a mold, carved it out and then used Dynatron to bond the 2 together. Just my $0.02 http://www.mp3car.com/vbulletin/show...t-monitor.html