MP3Car.com - View Single Post - Video Driver Problem. Display blank starting at Welcome Screen

Hessian · 08-04-2007, 12:09 AM

I have a VIA EPIA-CN13000G 1.3GHz VIA C7 running Tiny XP Beast.

I can run fine on the default driver. Can do everything but 3D.

If I install the UniChrome driver it goes blank right as it enters Windows.
After that I get no signal right after I boot up and it stays like that until I clear CMOS and reboot.

I was running fine for 4 days then this afternoon I started up and bam right back to the same problem. What TOTALLY

SUCKS is I had all my stuff put back together.

I might try to reflash the bios and see if that helps. I'm also wondering in the Sabrent SBT-TVFM / FM Radio / TV Tuner PCI Capture Card I had installed had any effects on it? I had it in the board, but I never could get the card to work. It did work on my home desktop.

What board are you using? Hope we can figure this one out.

08-04-2007, 12:09 AM	#2
Hessian Low Bitrate Join Date: May 2007 Posts: 105	Same Problem Here I have a VIA EPIA-CN13000G 1.3GHz VIA C7 running Tiny XP Beast. I can run fine on the default driver. Can do everything but 3D. If I install the UniChrome driver it goes blank right as it enters Windows. After that I get no signal right after I boot up and it stays like that until I clear CMOS and reboot. I was running fine for 4 days then this afternoon I started up and bam right back to the same problem. What TOTALLY SUCKS is I had all my stuff put back together. I might try to reflash the bios and see if that helps. I'm also wondering in the Sabrent SBT-TVFM / FM Radio / TV Tuner PCI Capture Card I had installed had any effects on it? I had it in the board, but I never could get the card to work. It did work on my home desktop. What board are you using? Hope we can figure this one out.