|
I've got another (self-inflicted) problem that started yesterday. I increased the baud rate from 56600 to 115200 and that was fine. It is deinfatley set at the new baud rate as indicated by the combination of led's when it is first powered on.
For some reason I cannot seem to connect to it through hyperterminal, or more so that I cannot send or recive any information from it. It does say that I'm connected, but whenever I type a command (eg, ati etc) it just brings back a load of gibberish. I don't have a log file as I'm at work, but it looks similar to wingdings font which is the same sought of thing you get when the baud rate isn't correct. Also when connected at 115200, the terminal sends each charachter as I press it (the pc side rx led lights up on the module whenever I type a letter) rather than it sending the full sentance when I press enter.
Should the settings (parity, stop bits, flow control etc) be any different when using 115200 as opposed to 56600?
__________________
I installed my carpc into my pet Kangaroo, mate.
|