MP3Car.com - View Single Post - Auzentech Card: can't get sound out of the sub channel (again)

hithere · 03-13-2008, 10:06 AM

Quote: Originally Posted by Nola111

Hey all,

I'm having issues getting sound to my sub out of of my Auzentech Prelude card. Since it uses Creative software, I followed the instructions in the following post that I found by searching...

http://www.mp3car.com/vbulletin/975373-post5.html

The key was using a y-splitter, and lo and behold, I got sound to the sub! Good right? Well no, because after two days, the card stopped sending the signal to the sub. (I know it's not the sub b/c I hooked an mp3 player to it to test it... the sub is fine).

The absolute only thing I did between the time the sub worked and didn't work, was install RoadRunner. (I use Centrafuse mainly). Installing RR couldn't have done anything, huh? So now, I've gone over and over and repeated the steps in the above post, and I can't get sound out of the sub/center channel of the card.

Does anyone have any ideas of something else I should try?

Thanks!

You know, I've had to fight with Creative software in the past and making sure it reads the same in terms of speaker setup (4.1, 2.1, 5.1, etc.) as it does under Windows speakers/audio control panel. Start from Road Runner/Winamp, move to creative setup, then check the control panel, in each place making sure that your speaker layout is reflected correctly.

03-13-2008, 10:06 AM	#2
hithere Variable Bitrate Join Date: Oct 2006 Location: Bear, DE, USA Posts: 230	Quote: Originally Posted by Nola111 Hey all, I'm having issues getting sound to my sub out of of my Auzentech Prelude card. Since it uses Creative software, I followed the instructions in the following post that I found by searching... http://www.mp3car.com/vbulletin/975373-post5.html The key was using a y-splitter, and lo and behold, I got sound to the sub! Good right? Well no, because after two days, the card stopped sending the signal to the sub. (I know it's not the sub b/c I hooked an mp3 player to it to test it... the sub is fine). The absolute only thing I did between the time the sub worked and didn't work, was install RoadRunner. (I use Centrafuse mainly). Installing RR couldn't have done anything, huh? So now, I've gone over and over and repeated the steps in the above post, and I can't get sound out of the sub/center channel of the card. Does anyone have any ideas of something else I should try? Thanks! You know, I've had to fight with Creative software in the past and making sure it reads the same in terms of speaker setup (4.1, 2.1, 5.1, etc.) as it does under Windows speakers/audio control panel. Start from Road Runner/Winamp, move to creative setup, then check the control panel, in each place making sure that your speaker layout is reflected correctly. __________________ Look here for DC/MD/VA/DE meet schedules