|
thanks, hope it helped some guys...
this mesh is a really nice technique, it's like fiberglass in the respect that the end result is much stronger than either component by itself. if you force it through the mesh it works like resin soaking through mat...
these new liliput bezels really suck for fabrication... there like a white clear plastic really... not very compatable with anything like most dash bezels. one thing that causes a lot of adhesion problems is not sanding well enough, or rather,not rough enough... you don't want some wimpy 120 or 180 sanding here on the larger areas to grab, rough it up good & deep, 40 grit maximum, this increases the effective surface area many times over & goes a long way in helping adheision... the areas that I don't want it to stick too I don't sand...
|