Hey, I got the LCD Controller Board from Hong Kong that was off ebay. Its this
http://cgi.ebay.com/VGA-TFT-LCD-Pane...742.m153.l1262
I had a custom cable made for my LCD Board. When I hook it up. The display lights up for a few seconds and says no signal (This is without vga running to it). This is good. When I hook up a VGA single to it (ie from my XBOX360) to the panel I get a crackling like noise on the LCD panel. I made a Female to Female connector because the guy who made the vga connector made it male, and my xbox360 cable is male. Im ordering a proper gender changer to see if thats the problem.
One major question I have and a picture that illustrates it is that on the vga cable there was a black wire with a little metal hook at the end. I assumed it goes to the back of the LCD panel underneath a screw to ground it. Is this correct. I have a picture that illistrates it.
Also does anyone have any ideas on hooking up the lcd driver board and inverter board physically to the back of the lcd panel so its not just resting on it. Thanks.
In the picture above you see how I have the black wire with metal ring going to the back of the lcd panel on a screw