MP3Car.com - View Single Post

jusatry · 03-13-2004, 06:55 PM

Quote: Originally Posted by none

Power good should be hooked up to "CN4" - are the two 2pin jumpers marked at all? A bit more info is available here: http://www.mgpower.com/specfile/MPD-810H.pdf

None

YOU ARE MY HERO

thank you, it is marked (CN X) the X being under the jumper, but that diagram clarified it for me completley.

I am on spring break, so this install should be done by thursday (if not, it may be a while after that

) but i will post pics and a quick write up (esp of the PSU) when i am done.

Thanks again None.

03-13-2004, 06:55 PM	#3
jusatry Maximum Bitrate Join Date: Nov 2003 Posts: 863	Quote: Originally Posted by none Power good should be hooked up to "CN4" - are the two 2pin jumpers marked at all? A bit more info is available here: http://www.mgpower.com/specfile/MPD-810H.pdf None YOU ARE MY HERO thank you, it is marked (CN X) the X being under the jumper, but that diagram clarified it for me completley. I am on spring break, so this install should be done by thursday (if not, it may be a while after that ) but i will post pics and a quick write up (esp of the PSU) when i am done. Thanks again None.