|
did it myself. was very easy. I just made a cardboard template of the sides. traced it on some 1/4 inch plywood. cut it out and put a 1/4 inch piece on top. fiberglassed the front to seal the unit and then cut out for the center console. There are a few braces that go along the bottom and just below where the monitor sits. Glassed the whole outside for extra measure and then filled it and spot putty and bam done.
Making the console only took 2 days. Making the motorized inners was the hard part and will be redoing it soon. I figured out a better way to get the screen to raise other than springs.
|