|
Extended Mold..
Something like this.
The diagram on the top shows what the current mold looks like in a general sense - thicker mold on the bottom (front of the bezel), thinner on the top (back of the bezel).
The diagram on the bottom shows what the extended mold will look like.
The original mold will be cut out underneath the modified section of the bezel (in green), and new rubber will be poured in place underneath the modified bezel (gray).
After the green section of the rubber cures, any overflow or excess rubber would be trimmed, and then a new back for the mold would be poured on top (red).
So I'll most likely have to re-pour a section of the bottom part of the mold (which is thick), and a new top (which is thin), so I'd have to use some more rubber, but not as much as I would need to pour a completely new mold.
|