|
M1-ATX Led
hi,
I'm having problems with my M1-ATX. I tried to find out what the led means, but couldn’t find any reference to this. Except for a post by Rando stating that it should blink when only the 5v rail has power.
I connected the m1 to an epia me 6000 and when the switched connector gets power, the m1 led lights up, the board power led lights up, but nothing else appends. I measured the power at the Molex, and on the yellow I always get 0.726V and on the red always 0V.
I’m going to try right now the same setup with a regular atx power supply..
__________________
Ikea Case. Epia M10000.M1-ATX. 512 Mb. 2,5" 80 GB HDD. 7" Lilliput. BU-303 GPS. Sony Joystick.
Status --> Lilliput Installed (not indash yet..)
BraveCar 2.5
|