I was able to do some fab work this weekend. I got the pc box almost done, just the lid left to cut and carpet. I'm also going to build a deck for the amp and cap. Also did some wiring, not much cause it took me way too long to get all the details on the engine compartment and the cable through the firewall.
The box is built with 3/4" MDF. Don't ask me the measurements because I don't know
I used a cardboard template and some improv.
Here is the box in the car
For wiring I replaced the battery terminals with Stinger battery terminals. These allowed me to connect the power and ground wires directly on the terminals without a lot of work.
Here is a closer look at the Stinger in-line fusebox with the digital read-out. Everything is wired up with 4ga all the way to the trunk where there will be a power distribution box. You can harldy see it but the fusebox is displaying 14.4 (the engine is running)
