|
epia sp13000 problems
ok so here is my situation.
im using an m1 psu and sp13000 mobo. i have been able to get the m1 to blink twice rapidly, which means a startup sequence error.
however, it doesnt even try to power up the motherboard at all. when i connect just a regular atx 20 pin with an atx psu the cpu fan spins, but nothing else receives power for more than a second.
i hear no beeps, even when i take out the RAM. i get no vga signal, or keyboard power other than when i switch on the psu and then the lights go off.
i was reading the sp13000 manual, and it showed a 2 pin slot where a 12v wire will "power the rest of the board". well, i found a 2 pin connector and wire from the m1. it was white and green. on the manual to the psu it says that should be connected to the power switch on the mobo. should that go in that 2 pin slot?
if pictures would help i can get some up.
thanks
__________________
via epia sp13000 mobo
512mb ddr ultra slim ram
100 gig hdd
mp3car in-dash TS
much more to come!
|