MP3Car.com - View Single Post

sharpmat007 · 11-17-2006, 02:19 PM

I either get sound out of the front or no sound at all. It seems like the interface between StreetDeck and the audio drivers is not configured correctly. I have tried different drivers(as well as the ones off the streetdeck cd as recommended for the infill). I am at the latest 1058 version as well.

In Windows(such as WMP10) the audio works perfectly. I can adjust all settings, but as soon as I go to Streetdeck...the fader, balance, channel adjustment, etc either cause all sounds to mute, a strange hum/buzz, or sound only from one or two channels. I have triple check my wiring as well. I thought it was something with the wiring as we didn't have an official install guide for a while, but I had everthing just as the manual stated.

I am also wondering if the Infill's may have been shipped with different audio chipsets and thats where the problem lies.

Not sure where Chuck is located, but I am in DC and would be willing to drive up to Baltimore to get this resolved! My only solution now is to tinker with all of the settings until I at least get sound out of the front channels...I then use an rca splitter so I can get it out to other channels. But if I make a mistake and touch either the fader or balance...the sound goes away again until I tinker for another half hour.

11-17-2006, 02:19 PM	#2
sharpmat007 Constant Bitrate Join Date: Nov 2006 Location: Washington, DC Posts: 213	I have exactly the same problem with my Infill I either get sound out of the front or no sound at all. It seems like the interface between StreetDeck and the audio drivers is not configured correctly. I have tried different drivers(as well as the ones off the streetdeck cd as recommended for the infill). I am at the latest 1058 version as well. In Windows(such as WMP10) the audio works perfectly. I can adjust all settings, but as soon as I go to Streetdeck...the fader, balance, channel adjustment, etc either cause all sounds to mute, a strange hum/buzz, or sound only from one or two channels. I have triple check my wiring as well. I thought it was something with the wiring as we didn't have an official install guide for a while, but I had everthing just as the manual stated. I am also wondering if the Infill's may have been shipped with different audio chipsets and thats where the problem lies. Not sure where Chuck is located, but I am in DC and would be willing to drive up to Baltimore to get this resolved! My only solution now is to tinker with all of the settings until I at least get sound out of the front channels...I then use an rca splitter so I can get it out to other channels. But if I make a mistake and touch either the fader or balance...the sound goes away again until I tinker for another half hour.