MP3Car.com - View Single Post - Startup / Shutdown Controller w/ LCD Char Screen

LUWE SYGABU · 01-19-2007, 01:42 PM

HAHA, I wondered if anyone heard my little girl banging on the car door. That was sooo funny.

OP - the select button is attached to the D2 pin, circuit it the same way all the other buttons are. Sorry about that oversight. And your board looks fantastic BTW, very good work! Don't forget to put a heatsink on your main power 7805 voltage regulator. And for the LCD power transistor, attache the base pin to the D6 pin, the collector to the +5v, and the other pin to the + PWR pin on the LCD. I would bench test it on a breadboard first , it should work theoretically.

01-19-2007, 01:42 PM	#35
LUWE SYGABU Low Bitrate LUWE SYGABU's CarPC Specs Join Date: Jan 2006 Location: Nebraska Vehicle: 2006 Honda Civic Posts: 100 My Photos: ()	HAHA, I wondered if anyone heard my little girl banging on the car door. That was sooo funny. OP - the select button is attached to the D2 pin, circuit it the same way all the other buttons are. Sorry about that oversight. And your board looks fantastic BTW, very good work! Don't forget to put a heatsink on your main power 7805 voltage regulator. And for the LCD power transistor, attache the base pin to the D6 pin, the collector to the +5v, and the other pin to the + PWR pin on the LCD. I would bench test it on a breadboard first , it should work theoretically. __________________ May all your dreams come true.....unless your dreams are nightmares ~ L.S. http://www.mp3car.com/vbulletin/show-off-your-project/67759-2006-honda-civic-breaking-ground-what-warranty.html Last edited by LUWE SYGABU; 01-19-2007 at 01:58 PM.