Interfacing with pre-95 Dodge - MP3Car.com

Sponsored links

Remove advertisements

		MP3Car.com > Mp3Car Technical > Engine Management, OBD-II, Engine Diagnostics, etc.
Interfacing with pre-95 Dodge

Mark Forums Read

Reply

Share

06-01-2009, 10:53 AM	#1
lbergamo Low Bitrate Join Date: May 2009 Location: Michigan, USA Posts: 65	Interfacing with pre-95 Dodge Anyone have any clue ? I sure do not but I would like to know. The specific vehicle in question is 1994, Dodge Van, B250, 360CI, Automatic Trans. Thank You in Advanced ! Leo Last edited by lbergamo; 06-01-2009 at 10:56 AM.

Remove advertisements
MP3Car.com Advertisement	Sponsored links

Reply

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pre 1995 OBD 2 interfacing...	lbergamo	General Hardware Discussion	2	05-19-2009 10:43 AM
2005 Dodge Ram Truckputer	kireol	Show off your project	11	11-20-2006 09:06 AM
Dodge Neon 2001	xpluisdf	Show off your project	21	11-13-2006 09:57 AM
Would a 802.11b PCMCIA Work for Windows 95?	grandamp3	Wireless Communications	2	03-17-2004 12:06 PM
95 Lite?	gizmos	Software & Software Development	1	08-03-2000 01:29 PM

Remove advertisements

All times are GMT -5. The time now is 11:45 AM.

$\'\'$

Remove advertisements