bigbuffs

Alright I'm trying to figure out how to connect my steering wheel controls to control my carpc. I'm looking at using the I-PAC because it seems to be a good value (I-PAC VE is $35 shipped) but I haven't found a whole lot about using the I-pac for SWC.

I'm just wondering if anyone could tell me if this will work for me. I have a 2000 grand prix that uses a single wire with varying voltage with each button press (8 total). Does anyone know if this will work?

__________________
[||||||----] - 60% Complete

onepuff

the i-pac uses a single ground and basically closes a circuit to emulate button presses that you program with the included software. I don't think the varying voltage will work. If you could get a wire run from each button it could work.

bigbuffs

Damn, I had heard people mention the IPac so I was hoping it might work. I guess I'm still trying to look for a cheap solution. Thanks for lettin me know

Anyone know if the fusion brain will work for my swc?

__________________
[||||||----] - 60% Complete

onepuff

You might try and take a look at the steering wheel controls. If you could run wires to each button it would work. The wires could be tiny as there's really no real voltage running through the wires. I used an ethernet cable to run wires to the buttons i hooked up. Might be worth a try.

2k1Toaster

Yup the FB will work.

__________________

b3tts32

So do you have a headunit at all? I'm trying to get my swc setup but everyone tells me I need a headunit. I have a vw gti.