NEC 8.4" Transflective Solution - Custom Kit - Page 8

MyPod · 06-04-2008, 04:52 AM

yep, i found that info in your panels data sheet. Can u give us a pic of the physical cable plugged into the board and another shot of it plugged into the panel.

alfauser · 06-04-2008, 08:57 AM

There is 1 information false in my first picture. Pin 19+20 = 3,3 Volt. What i wrote is wrong. The whole panel needs only 3,3V on 3 Pins. Pics comes later.

alfauser · 06-04-2008, 01:00 PM

So, here some pics of my board and the panel. I hope you can see enough.
Name: Photo-0033.jpg
Views: 246
Size: 12.8 KB

Name: Photo-0035.jpg
Views: 259
Size: 45.1 KB

Name: Photo-0036.jpg
Views: 249
Size: 53.8 KB

Name: Photo-0037.jpg
Views: 256
Size: 65.2 KB

alfauser · 06-04-2008, 02:10 PM

Is it possible, that 5 meters cable are to long for LVDS?

MyPod · 06-04-2008, 06:30 PM

To be honest i cant see much in your pics, i can see your board is correctly pinned to 3.3v, it also looks like you have joins in the wires, i'm not sure that this is a good idea.
Have you checked the wires for continuity?
It looks as though you have the wires going into the correct side of the LVDS output (all wires on the heatsink side) but i cant see if you have called the correct end of the plug to the panel pin 1, it might be worth double checking this.

If you need more help than i can offer its probably a good idea to start a new thread, this one has a lot of useful info and we dont really want to pad it out with noise.

thermoptic · 06-17-2008, 12:36 AM

Quote: Originally Posted by MyPod

Tested NEC_NL8060BC21-03 with LVDS controller onboard the VIA EPIA NX12000EG. Works very nicely

, no interface card required.

Hey, glad to hear you didn't need the video adapter! Looking good.

My setup is collecting dust and dog hair at the moment.

I am planning to ramp up again in July.

mrbean_phillip · 09-03-2008, 06:00 AM

Quote:

Is it possible, that 5 meters cable are to long for LVDS?Is it possible, that 5 meters cable are to long for LVDS?

Quote:

LVDS signal cable : In order to provide a clean signal it is recommended that LVDS signal cables are no longer than
46cm (18 inches). If loose wire cabling is utilized these can be made into a harness with cable ties. Care should be taken
when placing the cables to avoid signal interference. Additionally it may be necessary in some systems to add ferrite cores
to the cables to minimize signal noise.

Please keep us posted.