Custommx3

Ok heres a weird one. I hooked up my lilliput to my PC. and if I go to anything but VGA mode, its "over scan". IF I load my display drivers (and I know for a fact Im using the correct driver and Ive even tried older drivers) I get an error saying my display driver was writted for a previous version of windows. and it drops it to 4 bit color.

Im using an EPIA m9000. Any suggestions?

__________________
2007 Mazdaspeed 6

MP3Car.com

 

GingerPrince

Try turning off your TV out (both in the BIOS and in Windows drivers). My M9000 wouldn't even show the test bootup screen etc until I did this.

__________________

GingerPrince

Car changed for TVR Griffith 500, so computer de-installed. Using a Dension 100ix w/60Gb HD unit in the interim.

Carputer Install - http://www.stuffandting.com/carputer/
CarBox Software -- http://www.stuffandting.com/carbox/

yuprules

Warning, the Lilliput monitor does not like some resoution / hz combinations. Try lowering the resolution (like to 800x600) AND the hz (say 60hz).

Custommx3

I tried many, then it says over range. I may have to send this back.

__________________
2007 Mazdaspeed 6

yuprules

Ensure it is 60hz, anything over 800x600 is usually over 60hz and you have to manually change it to 60hz.

Custommx3

did that though...

__________________
2007 Mazdaspeed 6

zvi

I had the problem with installing VGA driver on my M10K, even on big monitor it did blackout, when restarting, then I found BIOS update on viavpsd.com and downloaded new vga driver, it helped, though vga driver has not non standard resolutions, like 848x480 (this is the best res for 7" lilliput). I am trying to find a sloution now, to twak somehow the driver to have thi res.
Zvi

MP3Car.com