switching modes on Lilliput without housing?

senseless228 · 04-18-2005, 08:21 PM

i have not yet gotten this, but the WRX housing for the lilliput 7" touchscreen looks like my best choice to have a nice double-din monitor thats flush witht he dash, however if i do this, all the buttons will be taken off as well, so how would i go about adjusting the monitor, (the fixup to fit in there has it rigged up to automatically turn on) but to change from VGA input to say the RCA input and whatnot, how would i go about doing that without buttons or to rig it myself to create those buttons and place them elsewhere?

96TransAm · 04-18-2005, 11:44 PM

the remote, or wire up custom buttons.

senseless228 · 04-19-2005, 04:17 PM

but the remote is infared, and the infared receiver will not be there anymore either

Gobby · 04-19-2005, 04:20 PM

extend the ir receiver by soldering a cable between the ir sensor and where it was mounted

Sonicxtacy02 · 04-19-2005, 04:26 PM

my receiver still works even though its behind the dash bezel.

maxxell · 04-19-2005, 06:33 PM

I assume you're talking about the wrx bezel from www.tmz.com. If so, you'll get it still with the receiver and buttons control board and ribbon cable. You can move the whole board wherever you want, or just attach the IR to its pins on the cable to the lilli or whatever you want.