Hard wire power to the Xenarc board?

[Will Albers]

As others may be aware, it looks like i have a modified Xenarc/Gain controller board modded by digitalww. Armen removed the tactile switches and power connector. The power connector section of the main board appears to have 4 holes in the board, and whoever modded it did a relatively sloppy job of solder so im redoing it. Basically, which of the 4 are ground and which are 12v? Im guessing the 2 on the bottom are ground and the 2 on the top are 12v and i should just jump the traces. Can anyone give me a hand with this? what goes where?

[thanatos106]

It will be good if you post a pic.

I'm old school so what I do in this cases is connect to power source and track it with a multimiter/voltimeter/tester or whatever you ganna call it.

Thanatos.

[Will Albers]

I'll see what i can do when i get back

[digitalww]

Top 2 are ground on all buttons.

Armen

Quote: Originally Posted by Will Albers

As others may be aware, it looks like i have a modified Xenarc/Gain controller board modded by digitalww. Armen removed the tactile switches and power connector. The power connector section of the main board appears to have 4 holes in the board, and whoever modded it did a relatively sloppy job of solder so im redoing it. Basically, which of the 4 are ground and which are 12v? Im guessing the 2 on the bottom are ground and the 2 on the top are 12v and i should just jump the traces. Can anyone give me a hand with this? what goes where?