Dudster

Hello.

I own a BMW Z3 roadster. I have been lurking in the forums for a while now and have found that the Xenarc 7" motorized LCD will fit in my car as it has been done in another BMW Z3.

I was thinking of going another route though. Will put my Travla C138 carputer in the booth in a custom made fibreglass together with my amplifiers etc.

As for the screen, I could go the usual route with a motorized 7" 16:9 monitor, but now I am thinking about finding a 4-5" touchscreen LCD running 640x480 or better and make a new a-pillar cover out of fibreglass housing the little monitor. Would be much more convenient than fitting a motorized monitor and much more sexy too.

So my question is, does anybody know of such a little monitor? I was also thinking to dissect a PDA and integrate that into the pillar, since it does have touchscreen etc, but then I would run into problems with an external harddrive. Or maybe I should just buy a 4GB memory card, would house enough MP3's...

turbocad6

this is perfect.... & at 800 nit brightness will blow away xenarc for sunlight viewable..... It's around $450 complete with controller & inverter & all.... but a touchscreen is extra..... it's a nice piece if you can fit the 6.4"..... they also have a 4" but it's less than 640X480....

__________________
MY NEWEST INSTALL:modded infiniti fx with big screen - "If my typing sucks it's probably because I'm driving....................."

first windows carpc install........my liquid cooled LVDS screen :D

Dudster

Hmm, I was hoping for something more readymade and cheaper. Browsed around the forum a bit just now and found that I can run a software called Innobec Sidewindow. It allows a PDA to replicate the VGA output on a carputer...But then again, I will not be able to use the PDA touchscreen to operate the carputer.

Will google around for a way to make a PDA interface with a 2,5" USB2.0 HDD.