in dash lilli TS question/fault

McGinty · 01-11-2006, 03:03 AM

hey

just installing my rig today, and the touch screen which was fine this morning is now seemingly ****ed. In the 4pt calibration, it doesnt detect when you push it on the two left hand crosses (top and bottom)

If you push on the rhs for the left crosses, it detects and moves on, but obviously this is not where the cross is. Any ideas why it would just go weird like that? What should i do?

McGinty · 01-11-2006, 05:58 AM

also, on the drawing screen, when i press on the center part of the screen, all i get is some red crosses and a yellow line slowly moving around in the top right. Every new press gets a cross and the yellow line kind of wanders around top right

Any remedies??? im crying i want my carpc

dazza666 · 01-11-2006, 03:42 PM

it sounds like your touchscreen controller is broken, uninstall and reinstall drivers, and try again, do a system restore so you can be sure your computer is clean, no doubt youve already tried this however!