icemann633

Hey guys,

I am a noob but this is beyond a noob question...

I have the 10.4 xenarc touch screen connected to the carputer i just built.

I booted up for the first time and everything went ok, except my slot load wouldnt load CDs.

I opend up the cast and fiddled around, closed her up, but when i turn it on now, the MONITOR WONT read an input signal. It says no signal input, with no other messages...

It flashes no input for a few secs and then goes into standby. To test, i put my desktops monitor on the carputer, and still no signal.

Without a monitor i cant go into the bios or anything...

PLEASE HELP!!

-keith

MP3Car.com

 

DJiK

First of all, this isn't your Xenarc's fault.
If you're using an onboard graphics card, a BIOS reset might help.
If it doesn't help, or you're using a video card, put a different card in there, and correct the issue.

__________________
For Sale: Carputer (CarPC) & RCA Y-Adapter
Newsflash: Take a look at my unsold stuff above, thanks!
Up Next: Make an OBD to Serial cable & Redo the "MMI buttons"

icemann633

I am using the MII12000 on-baord bios...How do i do a bios reset? Id assume that is Indeed what i need to do, but i cant see anything to access the bios...

Is there a way to do a hard rest on the board manually?

-Keith

icemann633

Fixed thanks!!

DJiK

Please share how you solved it so that the next newbie who's got the same problem knows how to deal with it.

__________________
For Sale: Carputer (CarPC) & RCA Y-Adapter
Newsflash: Take a look at my unsold stuff above, thanks!
Up Next: Make an OBD to Serial cable & Redo the "MMI buttons"

icemann633

Well it was a foolish mistake in itself...

When i messed around with the CD drive (which i still havent gotten to work), i had the IDE ribbon going to my hard drive on with the split power at pin 1 instead of the ribbon power...

I corrected the IDE setting and now everything is dandy except that the slot load drive wont take cds!

-Keith

MP3Car.com