hey guys,
im getting back into finishing my car pc 1 yr after i started
ive put the new drivers on for my Lilli TS motorized, and it didnt recognise the touschreeen.
After reboot, it is now there, and listed as a pointing device in Control Panel.
I go into the config of the new drivers, and it has a the wavy linearization and everything, but I CANNOT SEEM TO CALIBRATE IT.
when i click on any of those buttons (4pt 9pt etc.) it just says "Reading Parameters" with an empty progress bar for about 1min, then just goes back to the config program.
How can i actually calibrate the screen, any ideas?
Are these the right drivers?
http://www.egalax.com.tw/eg/drivers.htm
Linear Mode
