kingnasty

I am using a M10000 with my new xenarc 700tsv, and i cannot get it to utilize the whole screen no matter what resolution i choose... How can i achieve this? I tried searching xenarc resolution and didn't find what i was looking for, at least I don't think i did...

is there new drivers? a trick?? or will it just not do a true full screen using a m10k/xenarc combo??

RedGTiVR6

intersting...I knwo that it will do a true full screen as I had the exact same set-up last time around....as to why it's not doing it this time...what is it doing? cutting it down to a regular screen width?

maybe someone else has had this same problem and can chime in....

__________________

kingnasty

its the width of the screen w/out a problem, but it is not filling the screen top to bottom... i believe the resolution says 1140x4something in the upper left when it actually boots to the desktop...

help...

LeoTheHamster

http://www.mp3car.com/vbulletin/showthread.php?p=342713

Grab a (large) coffee and start reading

__________________
Leo

http://www.talkaudio.co.uk

Curly_cat

I've seen something similar to this with an M10K mobo. Dunno if it's the same problem.

I have my Gain/Xenarc set at 800x600 and noticed that if I changed the refresh rates on the monitor settings page of displat properties, the picture that was output to the screen changed in size vertically.

the desktop fills the screen when set to 800x600 @ 75Hz.

I don't know why it does this, but once I had it set to that, it displayed fine.

__________________

kingnasty

i wasnt trying to get the 800x480, i was just trying to get a resolution to utilize the whole screen instead of having these unused pixel border around my desktop. Either way i went and bought a mx4000 at cc and it solved the problem....

Curly_cat

Did you try changing the refresh rates for the onboard video to see if that also worked?

__________________