opus 90w wiring and computer wont shut

scw5179d · 04-30-2004, 04:17 AM

I got some questions about the wiring and setup

My Opus 90w came with red, black and blue wire.

I connected the

red to battary with fuse 10.
black to ground
blue to cig lighter(tap into the lighter) Add a on/off switch in between.

I am using VIA EPIA 800.

I can shut down the computer, my ign also shut down my computer BUT it will start up after about 2 seconds...by then, I am already out of the car.
The switch I added does not seem to work.

where did I go wrong?

Chairboy · 04-30-2004, 10:21 AM

In the manual for the power supply, there's a page where it lists a bunch of settings the BIOS needs to be configured for. Did you set every one of those? There are things in there like auto-power on that must be set properly.

scw5179d · 04-30-2004, 06:20 PM

Is the EPIA M-series setting and EPIA setting same? I got M-series instruction from Kris but I am using EPIA 8000. There is slight different in the BIOS. I tried to follow as close as possible even thou it is different. Let me go look into again.
This morning I went down and found the computer is still on. It was running the whole night.