|
Carnetix Fried Monitor
So my basic setup is. I have a good 12v(tested it with multimeter) coming into the car going into 1 12v battery and 1 ground of the carnetix. I soldered the connectors for my pc and monitor to 1 red primary output and 1 black ground for the pc and set JP6 to 19v output. For the monitor I soldered the brown and black to the monitor connector and had JP2 set to 12V and JP5 to +12V/13V Setting. I also have the CNX-P5V regulator installed. I followed the instructions to the dot. I had the pc and monitor plugged in but no USB device. Could that have been it? I also noticed that when I rev my engine or change radio stations my carnetix shuts off, or goes into shutdown mode and shuts down. I turn it on and smoke comes out of my monitor.....
__________________
"The text that you have entered is too long (12638 characters). Please shorten it to 10000 characters long."
Dam it!
"The text that you have entered is too long (10418 characters). Please shorten it to 10000 characters long."
|
Linear Mode
