A
firmware update for OBDLink CI (v1.1.1) is now available for download. It features a number of changes, new features, and bug fixes.
OBDLink CI ChangeLog
ScanTool.net LLC
v1.1.1 - 2009/08/14
-------------------
- BUG: ATST timeout could be exceeded on a busy bus
- BUG: All messages should be printed while monitoring (CAN messaged w/ invalid PCI were being dropped)
v1.1.0 - 2009/08/12
-------------------
- NEW: All header types can now be sent over KWP2000 protocol (1, 2, 3, and 4 bytes)
- NEW: Redesigned message filtering subsystem:
* Added pass filters (STFAP and STFCP commands)
* Added block filters (STFAB and STFCB commands)
* Added CAN flow control filters (STFAFC and STFCFC commands)
- NEW: Added STCAFCP and STCCFCP commands to add/clear CAN flow control 11-bit ID pairs
- NEW: Implemented mixed-mode CAN (ISO15765/ISO11898)
- CHG: Doubled maximum possible ISO refresh rate
- CHG: Optimized automatic filtering to work properly in marginal cases
- CHG: Improved automatic detection of KWP2000 protocols when using monitoring commands
- BUG: Fixed CAN filtering bug that could prevent 11-bit ID messages from being received
- BUG: Fixed a minor memory leak in ISO keep-alive module
- BUG: Suppress keep alives (ATSW00) should not get reset on ATD
- BUG: ATSWhh command should not restart keep alives
v1.0.0 - 2009/07/01
-------------------
- NEW: Initial release
Linear Mode
