So I was trying to change the bracket on my new D-Link DWL-AG530. I say new because this is the second one I've had (the previous one broke as well). This time I had only CAREFULLY pulled back the heat shrink they have attaching the antenna cable to this support post when the antenna came off. The solder points are very small and the connector does not even go through the board. It is just soldered to the surface. My question is:
How do I get this
Soldered back onto here
The places I have to solder are very small and I have no idea how I will resolder the point that is in the middle.
Thanks for any helpful hints.